All our projector lamps are original ones and have been taken strictly quality checked for beam performance,connections,voltages,and run-time.So you can trust it to work flawlessly in your projector.Furthermore,we will provide 90days warranty for after service.If you have any technical,damaged or other problem,please contact with us asap,we will try our best to help you!
POA-LMP105 Sanyo Projector Lamp Replacement. Projector Lamp Assembly with High Quality Genuine Original Philips UHP Bulb inside
Model Number: POA-LMP105
Lamp Life: 2000-3000 Hours
Packing: 1 unit each plain box
Quality:Original bare bulb with generic housing
Warranty: 180 days after shipping date.
Shipping way:DHL,UPS,FEDEX.Hongkong Post.
|This lamp can be used with |
|Brand ||Module POA-LMP105 |
|Christie Projector Lamp ||003-120242-01,LX300,LX380,LX450 |
|Eiki Projector Lamp ||LC-XG250,LC-XG300 |
|Sanyo Projector Lamp ||6103307329,PLC-XT20,PLC-XT20L,PLC-XT21,PLC-XT25,PLC-XT25I |
Tips to Installation and Extend your lamp life
Any glass components of a lamp should never be handled without gloves; deposits from fingerprints cause temperature 'hot spots'. In the long term, the accompanying temperature gradient stresses the glass resulting in early failure.
Clean the air filters of the projector. Blocked filters make the lamp overheat and fail early. Manufacturers can test for this kind of failure and any warranty becomes invalid. Always ensure that there is good airflow around the projector.
If you are fitting a bulb into an existing module housing, ensure the terminals are not over tightened as the ceramic can be cracked and reduce the electronic insulation of the lamp. Alternatively, if they are under tightened, it can cause arcing on the terminal which puts undue load on the ballast that can then lead to a failure.
2.Extend your lamp life
Never touch the bulb with your fingers, always use a cloth for handling.
3.Switching projector off
Always switch off using the remote control and not by disconnecting the power, the projector will invariably go into a cool down mode where the image is turned off and the fan accelerates to cool the lamp in a controlled manner. The temperature of an operating lamp is many 1,000's of degrees. Disconnecting the power to the projector prior to the above process causes the glass in the lamp to cool unevenly and will result in a stress fracture and early lamp failure.
4.Shock and vibration
Lamp failure can be due to mechanical shock. A hot lamp filament is very fragile, you should always make sure that the unit is turned off and the lamp is cool before moving the unit.
If your projector is equipped with a "high/low lamp" switch you can extend your average lamp life by using the "low lamp" position whenever possible.
Thank you for your visting,contact us Let's talk more details!!